Blistered Veneer

Think you need to resort to runners or doilies for blistered veneer well think again it's as easy to fix as ironing a shirt!

1. Small blisters can be fixed with heat and an iron is the ideal tool! It will reactivate the glue and settle the blister. Cover the damage with a piece of flat, smooth cardboard. Lay a hand towel over the cardboard then press a hot iron on the towel. Make sure the iron isn't overlapping the side of the cardboard or you'll cause more problems! Hold the dry iron in place for a few seconds and then check to see if the blister is flattening, if not repeat it until it does. Watch your fingers cause the cardboard can get pretty hot.

2. How about a bigger blister? If it's not slit down the middle already use a utility knife to make a cut down the center along the grain. Gently scrape out any old glue without causing more damage. Use a toothpick or a cotton swab to put a little wood glue under the blister, then press the two sides together smoothing toward the center of the damage. Then repeat the process that you used for the smaller blister to flatten it. If the sides start to overlap, just grab a utility knife to cut off any excess to get a nice smooth seam .

It's just that simple!